FIBARO Dimmer 2 | 250W

Fibaro Dimmer module has been updated and is now called Dimmer 2, designed for use with all light sources. Dimmer 2 can be connected to 2- or 3-wire installations. Fibaro Dimmer 2 can switch on/off and dim connected light sources via Z-Wave network or via the connected wall switch.

Automatically detects the connected device, is equipped with automatic overload protection and a soft start function (when the lights are switched on, the lights dim from 0% to 100% strength).
Works as a dimmer or as a switch, with three-wire or two-wire installations.
When using old fluorescent light sources or other old type light sources, only the switch mode is available.

The improvements:
- Automatically detect the type of light source and adapt to it (calibrate)
- Real-time measurement of energy consumption
- Supports both Leading and Trailing edge (Phase cut & cut-off)
- Latest generation 500 Z-Wave chip
- Now supports Z-Wave PLUS in addition to Z-Wave
- DEKRA and Z-Wave certified
- Built-in RGB LED for installation support
- Uses MOSFET technology

Features:

As a dimmer, this module works with:

• Conventional fluorescent lamps
• 230V halogen lamps
• 12V halogen lamps
• Dimmable LED lamps

As a switch, this module works with:

• Compact fluorescent lamps
• LED lamps
• Old type fluorescent lamps

• Smallest device in the world (of its kind) !!!

Technical Data:
• Power source 230V +/-10%, 50Hz,
• Max output power 250W (resistive loads only)*,
• Conforms to UE requirements:EN55022 (radio wave interference), EN61000-6 (safety of use),
• Surge protection: 2.5A,
• Ambient temperature: 10oC - 40oC,
• To be mounted in standard wall switch boxes Ø ≥ 50mm,
• Radio protocol: Z-Wave * Z-Wave+
• Radio Frequency 868.4 MHz EU; 908.4 MHz US; 921.4 MHz ANZ; 869.2 MHz RU,
• Antenna range: up to approx. 50 meters outdoor, or up to 30 meters inside
(depends on building structure),
• Outside dimensions (L x W x H) 42mm x 36mm x 15mm.
* in case of loads other than resistive, current intensity may not exceed 1.8A